Vacuumm Chuck is used the compressor
to clamp at products.
*In the past time vacuum chuck
always used pump to work, But our
Vacuum Chuck works throught
compressor only. |
| 1.without pump |
| A. |
this product adopts
vacuum ejector. only through
compressor can work. |
| B. |
even machine had
inhaled cooling oil. cooling water
or rubbish etc.
Vacuum Chuck also can exclude them. |
| C. |
Vacuum Chuck had
improved many imes and machine to
simplify.
So less breakdown and easy to
maintain. |
| 2.for available
all process producs |
| A. |
work well for up
layer process. side process.
grinding. also easy to drill work. |
| 3.at will to
adjust size |
| A. |
according to size of
process, products to change assemble
and adjust machine. |
| B. |
according to process
products size to place station. |
| 4.place of key
trough and workstopper |
| A. |
vacuum chuck of
bottom install key trough. so can
get exact parallel angle and
vertical angle. |
| B. |
vacuum chuck of side
install wto works stoppers, prevent
from momentum. |
| 5.following are
suitable for clamping process |
| A. |
light metal,hard
metal,iron board etc. |
| B. |
plastic products,
ceramics, glass, alminum, stainless
steel, wood, stone materials etc.
All un-magnetic products and
un-ventilation smooth products. |
| C. |
products of small
shape, smooth and complicated
process. |
| D. |
outside of products
needfull processing but no one can
clamp. |
| E. |
products of
traditional process will cause scar
crooked. curved. |
| F. |
products of super
thin can't clamp. |
| G. |
products of smooth
but irregular shape. |
| 6.major assembly
machine end using way |
| A. |
use semi-automatic
fraise process. |
| B. |
use fraise or C
fralse to process of cover and side. |
| C. |
use scuplture
machine to make word or precise
process. |
| D. |
group secondary
machine to process. |
| 7.crisis |
| A. |
vacuum chuck use
vacuum press to clamp products and
to process.
F-=A ⊙ P/700 F(kg) A=lnhale area(cm2)
P=(mmHg) |
| B. |
Vacuum press and sie
of area. |
| C. |
air supply should
keep steady. |
| D. |
Before process
products should clean. |
| E. |
seal condition and
density whether excellent. |
| F. |
the clamping area
and ventilation. |
| G. |
warmth, humidity and
curved condition of products. |
| 〈 |
PARALLELISM 0.01mm |
| 〈 |
Material:S55C |
| 〈 |
Product:GROUNDED |
| 〈 |
Character:airblow
circuit to conceal |
| 〈 |
Plate:HEAT TREMENT |
| 〈 |
Auxiliary
parts:silicone 4Ø⊙2m |
高基INQUIRIES